Use ADsorb-it® Filtration Fabric

Remove Oil, Oil Sheen, Oil-Borne Contaminants and Suspended Solids from Water.
Reusable Products. Made From Waste. Used to Clean the Environment. Ultimately a Fuel Source.
"It doesn't get any greener than that!"

Adsorb-it for oil spill response Spill Response

Use Boom Covers and ShoreGuard/ DumboSurfers for oil and oil sheen recovery on open waters.

ADsorb-it's wicking action allows the oils, oil sheen and oil-borne contaminants to be contained in the entire fabric as opposed to only the point of contact. Oil and oil sheen adhere to the ADsorb-it® fibers and are not displaced by water.

Adsorb-it for shoreline protection Shoreline Protection

Conforms easily to uneven surfaces such as shorelines, streambeds and rock formations; or may be configured into a
barrier fence as used by BP for the
Gulf Oil Spill.

ADsorb-it inhibits oils and oil-borne contaminants in water from impacting the land, and contaminants on land from impacting the water. Equally effective wet or dry; in salt or fresh water. The oil displaces the water in the fabric.

Adsorb-it for oil recovery Oil Recovery

Allows the recovery of adsorbed oils and oil-borne contaminants.

Oil may be recovered from the filtration fabric by physical means (wringing, pressing, centrifuge, etc.) after which you may reuse it with little reduction in its efficacy.

Adsorb-it for ditch or pond liner Ditch or Pond Liners

Excellent liner for drainage ditches or retention ponds where oil pollution is a problem.

Oils are held in the filter fabric matrix and allowed to degrade naturally. ADsorb-it® inhibits oil and oil-borne contaminant pollution on water from spreading to the surrounding soil or perking from the soil to the water.


Adsorb-it for oil water separators Pump Underground Vaults

Our brand new Vault Maintenance System allows you to pump water from underground vaults directly into the environment.

A staged filtration system in an easy-to-use sock configuration that filters TSS and Oil & Grease to below regulatory guidlines. See the test data that shows TSS Removal at 99.4% and Oil & Grease Removal at Non-Detect.

Adsorb-it for wastewater filtration Stormwater Filtration

Filter oil and oil-borne contaminants, control bacterial proliferation in: ditches and piping, retention ponds, sumps, and catch basins.

ADsorb-it® products are available for use in catchbasins, approved by the Dept of Ecology, and much easier to install than other available catch basin inserts. We have Antimicrobial products available to control bacteria in stagnant or low-flow conditions.


Adsorb-it for oil water separators Oil Water Separators

Use as a filter media before the final discharge to eliminate oil sheen.

See a simple Polishing Filter Pack Unit design with screen plates covered with ADsorb-it®, and a drop-in Oil Water Separator Filter Curtain design. The US Navy uses ADsorb-it on the shoreline beneath their oil/water separator outfall to prevent any oil or oil sheen from impacting the water.

Adsorb-it for wastewater filtration Wastewater Filtration - FOG

Use in interceptors and grease traps or use to filter industrial mop water.

Highly effective in the removal of fats, oils, and greases (FOG) when used for filtration -- virtually eliminating system blockages due to grease buildup. Excellent for the removal of oil and oil-borne contaminants from any wastewater stream.



Adsorb-it as a sorbenta Sorbent

"ADsorbs" (absorbs) up to twenty times its weight in oils.

Outperforms typical polypropylene products (the industry standard) and allows the free flow of water while retaining the oils and oil-borne contaminants in the fabric matrix.

Adsorb-it as a fuel sourcea Fuel Source

As opposed to land fill disposal, ADsorb-it can be incinerated for its fuel value.

ADsorb-it has a BTU rating of 7600/lb. When ADsorb-it is saturated with oil, it has a higher BTU/lb rating than coal. ADsorb-it is incinerable to less than 1% ash.

Contact Information